Jump to content

As of July 17, 2015, the LabJack forums here at forums.labjack.com are shut down. New registrations, topics, and replies are disabled. All forums are in a read-only state for archive purposes.

Please visit our current forums at labjack.com/forums to view and make new posts. To post on the current forums, use your labjack.com login account. Your old LabJack forums login credentials have been retired. There are no longer separate logins for labjack.com and LabJack forums.


Photo

U3 with SSI sensor

SSI

  • Please log in to reply
2 replies to this topic

#1 phillies9864

phillies9864
  • Members
  • 2 posts

Posted 28 April 2015 - 07:40 AM

Can the U3 communicate via SPI with a slave that uses SSI?  If so, how would the signals connect?

 

SPI (U3) has:

MOSI

MISO

CLK

CS

 

SSI sensor has:

Pulses + 

Pulses - 

Data +

Data -

 

The SSI protocol is discussed more on page 82 of the attached PDF.

Attached Files



#2 LabJack Support

LabJack Support
  • Admin
  • 8677 posts

Posted 28 April 2015 - 08:33 AM

The U3 does not support SSI. The hardware interface is not compatible with the U3's IO and the U3 does not have software capable of interpreting the signaling. That being said, it may be possible to use SPI, a hardware interface to acquire a bit stream that can then be analyzed in software.

 

Sounds like a fun challenge, but not a practical solution.

 

http://en.wikipedia....erial_Interface



#3 phillies9864

phillies9864
  • Members
  • 2 posts

Posted 29 April 2015 - 08:19 AM

Thank you for your reply, I was coming to the same conclusion.




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users