Jump to content

As of July 17, 2015, the LabJack forums here at forums.labjack.com are shut down. New registrations, topics, and replies are disabled. All forums are in a read-only state for archive purposes.

Please visit our current forums at labjack.com/forums to view and make new posts. To post on the current forums, use your labjack.com login account. Your old LabJack forums login credentials have been retired. There are no longer separate logins for labjack.com and LabJack forums.


Which Inputs for Measurement

  • Please log in to reply
1 reply to this topic

#1 Resistor101

  • Members
  • 4 posts

Posted 19 February 2014 - 01:29 AM


with my new LabJack U3 i can mesure the voltage of a simpel electronics with an accumulator. I used AIN1 and GND as inputs for my analog signal.

Now i want to mesure the current. So I installed a shunt to mesure its voltage to get the current. I used AIN2 and AIN3 as inputs, but ProfiLab doesn´t show me the correct value.

Which inputs should i use for it?


Thanks for the good support.

#2 LabJack Support

LabJack Support
  • Admin
  • 8677 posts

Posted 19 February 2014 - 08:22 AM

See the following:






If you are still stuck, I suggest posting a wiring diagram of your setup.

0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users