Jump to content

As of July 17, 2015, the LabJack forums here at forums.labjack.com are shut down. New registrations, topics, and replies are disabled. All forums are in a read-only state for archive purposes.

Please visit our current forums at labjack.com/forums to view and make new posts. To post on the current forums, use your labjack.com login account. Your old LabJack forums login credentials have been retired. There are no longer separate logins for labjack.com and LabJack forums.


Photo

Problem recognizing multiple U3 devices


  • Please log in to reply
1 reply to this topic

#1 eatlas

eatlas
  • Members
  • 1 posts

Posted 01 February 2013 - 08:42 PM

I seem to have a problem with DaqFactory recognizing a 2nd U3-HV LabJack that I am trying to install. The intial set-up had the single LabJack as Device #0. With the second LabJack, using LJControl, I assigned numbers 1 and 2 to the original and new LJ. LJ Control recognizes both devices with no problem. I reassigned Device #0 channels to #1 in the ctl program, and that worked fine. However, I could not address the 2nd device. The error was that the device could not be found (or was not recognized). Is there something I missed in the configuration? I had thought the 2nd LJ would be identified automatically. I have seen some posts related to multiple devices in LabView, but not with DaqFactory. Can you help me track the problem? Thanks

#2 LabJack Support

LabJack Support
  • Admin
  • 8677 posts

Posted 04 February 2013 - 11:59 AM

Looks like this was resolved on AzeoTech's forum:

http://www.azeotech....ces/#entry17927


0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users